Change 1 2-737
TM 9-2320-365-20-1
(1) Remove instrument panel assembly for
access (para 7-15).
(2) Disconnect connector PX15 from main
light switch.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter
to main light switch pin K.
(5) Connect negative (-) probe of multimeter
to main light switch pin N.
(6) Position main light switch to BO DRIVE
(TM 9-2320-365-10) and note reading on
multimeter.
(7) If continuity is not present, replace main
light switch (para 7-17).
(8) Position main light switch to OFF
(TM 9-2320-365-10).
CONTINUITY TEST