TM 9-2320-365-20-1
2-883
CONTINUITY TEST
(1) Disconnect connector P6 from horn.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter to
connector P6.
(4) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5) If continuity is not present, repair wire 3035
(para 2-40) or replace front lights cable
assembly (para 7-74).
(6) If continuity is present, replace horn
(para 7-44).
(7) Connect connector P6 to horn.
(8) Position front grille on cab with washer and
screw.
(9) Position two washers and screws in front
grille.
(10) Tighten screw to 48-60 lb-in. (5-7 N·m).
(11) Tighten two screws to 24 lb-in. (3 N·m).