TM 9-2320-365-20-1
2-1007
CONTINUITY TEST
(1) Set multimeter to ohms.
(2) Connect positve (+) probe of multimeter to
connector P115-22.
(3) Connect negative (-) probe of multimeter to
PDP, terminal 86, where WTEC III relay K37 was
removed, and note reading on multimeter.
(4) If continuity is not present, repair wire 112
(para 2-40) or replace WTEC III dashboard
cable assembly (para 7-11).
(5) Connect connector P115 to WTEC III transmission
ECU.
(6) Connect connector clamp on connector P115.