(1) Disconnect batteries (para 7-48).
Remove plastic cable ties as required.
(2) Remove two screws and washers from front
(3) Remove screw, washer, and front grille from
(4) Remove power distribution panel (PDP) cover
(5) Set multimeter to ohms.
(6) Connect positive (+) probe of multimeter to
terminal X3 on power distribution panel
(7) Connect negative (-) probe of multimeter to
terminal lug TL64 and note reading on
(8) If continuity is not present, go to step 6 of
Change 1 2-256.1