Change 1 2-265
TM 9-2320-365-20-1
(1) Disconnect batteries (para 7-48)
(2) Remove relay K2 from PDP.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter to
relay K2 socket 30 on PDP.
When testing to terminal X1 on PDP, ensure
that multimeter probes come in contact with
the outside metal ring. Failure to comply
may result in false troubleshooting test
results.
(5) Connect negative (-) probe of multimeter to
terminal X1 on PDP and note reading on
multimeter.
(6) If continuity is not present, repair wire
1602 from terminal X1 on PDP to relay
K2 socket 30 on PDP (para 2-40) or
replace WTEC II dashboard cable assembly
(para 7-10) or WTEC III dashboard cable
assembly (para 7-11).
CONTINUITY TEST
CAUTION