2-6. SERVICE BEFORE OPERATION (CONT)
(5) Transfer Case Inspection (TM 9-2320-365-10).
(a) Check level of lubricant at fill plug.
(b) Inspect lubrication pump and external hoses for evidence of leakage.
(c) Operate driveline control and observe drive power to front axle.
(d) Inspect bolts on driveline U-joints.
(6) Electrical System Inspection (TM 9-2320-365-10).
(a) Inspect battery cable connections and clean and tighten as necessary.
(b) Check all lights for burned out lamps, loose connections, and dirty or broken lenses.
(c) Check that alternator is charging batteries properly.
(d) Check that all electrical equipment functions properly.
(7) Air System Inspection (TM 9-2320-365-10).
(a) Drain any water from reservoirs.
(b) Inspect all accessible air hose and tubing connections for leakage.
(8) Steering System Inspection (TM 9-2320-365-10).
(a) Check steering hydraulic reservoir for proper fluid level.
(b) Examine steering linkage and steering gear for damage incurred during shipment.
(c) Examine steering hoses and connections for evidence of leakage.
(d) Check steering system for proper operation during road test.
(9) Chassis and Front and Rear Axle Inspection (TM 9-2320-365-10).
(a) Check all lubricant levels.
(b) Check axle housing pressure vents to ensure freedom from foreign matter.
(10) Tire Inspection.
(a) Check tire pressure (TM 9-2320-365-10).
(b) Inspect tires for serious cuts, bubbles, cracks, bruises, dry-rot, foreign objects, or exposure of internal cords.
Remove foreign objects lodged between treads (TM 9-2320-365-10).
(c) Check all wheel mounting nuts for proper torque (para 12-4).