CONTINUITY TEST
(1) Remove nut, lockwasher, terminal lug TL20
and lockwasher from RH rear marker light
screw. Discard lockwashers.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter to
terminal lug TL20.
(4) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5) If continuity is not present, repair wire 3095
from terminal lug TL20 to terminal lug TL21
(para 2-40) and go to step 6 of this fault if
required or replace rear lights cable assembly
(para 7-75) and go to step 1 of this fault.
(6) If continuity is present, repair wire 489 from
splice E15 to splice E17 (para 2-40) and
go to step 6 of this fault if required or replace
rear lights cable assembly (para 7-75) and
go to step 1 of this fault.
(7) Install lockwasher, terminal lug TL20,
lockwasher, and nut on RH rear marker
light screw.
Change 1 2-584.33
TM 9-2320-365-20-1