TM 9-2320-365-20-1
2-609
CONTINUITY TEST
CONTINUITY TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
lamp socket.
(3) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4) If continuity is not present, repair wire 3091
(para 2-40) or replace front lights cable
assembly (para 7-74).
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
inside of blackout drive light housing.
(3) Connect negative (-) probe of multimeter to
lamp socket and note reading on multimeter.
(4) If continuity is not present, replace blackout
drive light (para 7-30).
(5) If continuity is present, replace lamp
(para 7-30).
(6) Install lamp in socket.
(7) Install gasket and cover on housing with
three screws.