Change 1 2-1589
TM 9-2320-365-20-2
CONTINUITY TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
connector P116-32.
(3) Connect negative (-) probe of multimeter to
connector PX33P and note reading on
multimeter.
(4) Connect negative (-) probe of multimeter to
all other sockets in connector PX33, one at
a time, and note reading on multimeter.
(5) If continuity is not present in step 3, or
continuity is present in step 4, repair wire
143 (para 2-40) or replace WTEC III
dashboard cable assembly (para 7-11).
(6) Connect connector PX33 to WTEC III TPSS.
(7) Install instrument panel assembly (para
7-15).
(8) Clear diagnostic codes (para 8-5).