TM 9-2320-365-20-3
7-78. REAR INTERVEHICULAR 12 VDC (7 PIN) CABLE REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Batteries disconnected (para 7-48).
Tools and Special Tools
Tool Kit, Genl Mech (Item 44, Appendix C)
Goggles, Industrial (Item 15, Appendix C)
Materials/Parts
Ties, Cable, Plastic (Item 76, Appendix D)
Nut, Self-Locking (2) (Item 116, Appendix G)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris.
Failure to
comply may result in injury to personnel.
a. Removal.
NOTE
Remove plastic cable ties as required.
(1) Disconnect connector J52 (1) from connector P52R (2).
(2) Remove two self-locking nuts (3), screws (4), washers
(5), and rear intervehicular 12 vdc (7 pin) cable (6) from
vehicle. Discard self-locking nuts.
Change 1
7-327