(18) Install inner bevel side gear (15) on spindle (12).
If alignment pins on wheel bearing nut do not
line up with alignment holes on inner bevel
side gear, loosen wheel bearing nut until pins
and holes are aligned. Do not loosen wheel
bearing nut more than one spline tooth.
Failure to comply will result in damage to
(19) Align pins (16) on wheel bearing nut (14) with alignment
holes in inner bevel side gear (15).
(20) Remove inner bevel side gear (15) from spindle (12).
Record measurement taken in step (21).
Steps (21) through (24) are not required when
Maintenance Checks and Services (PMCS)
(21) Measure depth from surface of wheel bearing
nut (14) to face of wheel end hub (2).