10-3. DIFFERENTIAL SPIDER ASSEMBLY REPLACEMENT (CONT)
Dry cleaning solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves;
use only in well ventilated area; avoid contact with skin, eyes, and clothes, and do not
breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the
flashpoint for Type I dry cleaning solvent is 100 degrees F (38 degrees C) and for Type II is
130 degrees F (50 degrees C). Failure to comply may result in serious injury or death to
I f personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts
eyes, immediately flush eyes with water and get immediate medical attention. Failure to
comply may result in injury to personnel.
Compressed air used for cleaning purposes will not exceed 30 psi (207 km/h). Use only with
effective chip guarding and personal protective equipment (goggles/shield, gloves, etc).
Failure to comply may result in injury to personnel.
Thoroughly clean all metal parts with dry cleaning solvent and dry using compressed air prior to
(1) Inspect inner bevel side gear (1) and outer bevel side
gear (2) for cracked or broken gear teeth, scoring,
pitting, and corrosion. Replace inner and/or outer bevel
side gear that fail inspection.