TM 9-2320-365-20-4
b. Installation.
(1) Position insulation sleeving (1) on wires 3085A (2),
1499A (3), and 400 (4).
(2) Strip approximately 1/4 in. (6 mm) of insulation from
wires 3085A (2), 1499A (3), and 400 (4).
(3) Solder wire 3085A (2) to heater connector J244D (5).
(4) Solder wire 1499A (3) to heater connector J244C (6).
(5) Solder wire 400 (4) to heater connector J244A (7).
(6) Position heater connector J244 (8) in raceway (9) with
matchmarks aligned.
(7) Install three screws (10), lockwashers (11), and nuts (12)
in heater connector J244 (8).
Change 1
16-301