Cab latch must be adjusted so that it rides
squarely on the support pins and does not
contact the welded area of the support pins.
Failure to comply may result in damage to
(4) Adjust cab latch (1) on support pin (6).
(5) Raise cab (TM 9-2320-365-10).
Do not allow cab latch to change position
while tightening screws. Failure to comply
may result in damage to equipment.
(6) Tighten two screws (4) to 34-44 lb-ft (44-60 N·m).
(7) Lower cab (TM 9-2320-365-10-1).
End of Task.