CONTINUITY TEST
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
(1) Disconnect connector P87 from backup light
connector.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter to
connector P51 socket 2.
(4) Connect negative (-) probe of multimeter to
connector P87 and note reading on
multimeter.
(5) If continuity is not present, repair wire 490
from connector P51 socket 2 to
connector P87 (para 2-40) or replace rear
lights cable assembly (para 7-75).
(6) Connect connector P87 to backup light
connector.
(7) Connect connector P51 to connector J51.
(8) Install PDP on dashboard with three screws.
(9) Install three washers and screws in PDP.
Change 1 2-657
TM 9-2320-365-20-1
