TM 9-2320-365-20-1
2-701
CONTINUITY TEST
CONTINUITY TEST
(1) Disconnect connector PX14 from hazard
lights switch.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter to
connector PX20-A.
(4) Connect negative (-) probe of multimeter to
connector PX14-6 and note reading on
multimeter.
(5) If continuity is not present, repair wire 1568
(para 2-40) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(6) Connect connector PX14 to hazard lights
switch.
(7) Install instrument panel assembly (para 7-15).
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
connector PX20-C.
(3) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4) If continuity is not present, repair wire 3049
(para 2-40) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(5) If continuity is present, replace flasher unit
(para 7-24).
(6) Connect connector PX20 to flasher unit.
(7) Install flasher unit on dashboard with two
washers and screws.
(8) Install kick panel (para 16-3).
