TM 9-2320-365-20-1
2-861
CONTINUITY TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
connector PX22-1.
(3) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4) If continuity is not present, go to step 5 of
this fault.
(5) Connect connector PX22 to windshield
wiper motor.
CONTINUITY TEST
(1) Remove instrument panel assembly for access
(para 7-15).
(2) Disconnect turn signal switch connector from
connector P18.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter to
turn signal switch connector terminal 6.
(5) Connect negative (-) probe of multimeter to
turn signal switch connector terminal 4.
(6) Position windshield wiper switch to high
(TM 9-2320-365-10) and note reading on
multimeter.
(7) If continuity is not present, replace turn
signal switch (para 7-25).
(8) If continuity is present, replace windshield
wiper motor (para 18-4).
(9) Position windshield wiper switch to off
(TM 9-2320-365-10).
(10) Connect turn signal switch connector to
connector P18.
(11) Install instrument panel assembly (para 7-15).
(12) Install PDP on dashboard with three screws.
(13) Install three washers and screws in PDP.
(14) Install PDP cover (para 16-2).
