TM 9-2320-365-20-1
2-871
CONTINUITY TEST
CONTINUITY TEST
(1) Remove instrument panel assembly for
access (para 7-15).
(2) Disconnect windshield wiper ECU from
connector PX21.
(3) Disconnect connector P18 from turn signal
switch connector.
(4) Set multimeter to ohms.
(5) Connect positive (+) probe of multimeter to
connector PX21-1.
(6) Connect negative (-) probe of multimeter to
connector P18-9 and note reading on
multimeter.
(7) If continuity is not present, repair wire 1599
(para 2-40) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
turn signal switch connector terminal 9.
(3) Connect negative (-) probe of multimeter to
turn signal switch connector terminal 5.
(4) Position windshield wiper switch to intermittent
(TM 9-2320-365-10) and note reading on
multimeter.
(5) If continuity is not present, replace turn
signal switch (para 7-25).
(6) Position windshield wiper switch to off
(TM 9-2320-365-10).
(7) Connect windshield wiper ECU to
connector PX21.
(8) Connect connector P18 to turn signal switch
connector.
(9) Install instrument panel assembly (para 7-15).
(10) Install PDP on dashboard with three screws.
(11) Install three washers and screws in PDP.
(12) Install PDP cover (para 16-2).
