TM 9-2320-365-20-1
2-877
CONTINUITY TEST
(1) Remove instrument panel assembly for access
(para 7-15).
(2) Disconnect turn signal switch connector
from connector P18.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter to
turn signal switch connector terminal 4.
(5) Connect negative (-) probe of multimeter to
turn signal switch connector terminal 6.
(6) Position windshield wiper switch to high
(TM 9-2320-365-10) and note reading on
multimeter.
(7) If continuity is not present, replace turn signal
switch (para 7-25).
(8) Position windshield wiper switch to off
(TM 9-2320-365-10).
(9) Connect turn signal switch connector to
connector P18.
(10) Install instrument panel assembly (para 7-15).
