TM 9-2320-365-20-1
2-899
CONTINUITY TEST
(1) Remove kick panel (para 16-3).
(2) Disconnect connector P99 from connector J99.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter to
connector P99-2.
(5) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(6) If continuity is not present, repair wire 1804
(para 2-40) or replace WTEC II dashboard cable
assembly (para 7-10) or WTEC III dashboard
cable assembly (para 7-11).
(7) If continuity is present, repair wire 1804
(para 2-40) or replace chemical alarm kit
cable assembly (para 7-52).
(8) Connect connector P99 to connector J99.
(9) Install kick panel (para 16-3).
