TM 9-2320-365-20-1
2-1003
CONTINUITY TEST
(1) Remove WTEC III relay K37 from PDP.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter to
PDP, terminal 85, where WTEC III relay K37 was
removed.
(4) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5) If continuity is not present, repair wire 3101
(para 2-40) or replace WTEC III dashboard cable
assembly (para 7-11).
