E-8.   M1079 WINDOW SASH GLAZING SEALS Fabricate the M1079 window sash glazing seals according to the following steps.   Refer to the following parts list for materials. Description Material Part Number CAGE Code Cut Length Window Sash Top/Bottom Seal 941P00001 0SHR6 26-13/16 in. (681 mm) Window Sash Side Seal (van body serial numbers 001 through 190) 941P00001 0SHR6 28-1/2 in. (724 mm) Window Sash Side Seal (van body serial number 191 and higher) 941P00001 0SHR6 12-11/16 in. (322 mm) a.  Dimensions are in inches (millimeters). b.  Cut seal material to the specified length using a fine-toothed hacksaw or other suitable cutting tool. NOTE Cut  miters  so  that  short  side  of  seal  faces toward glass. c.  Cut 45-degree miters on ends of window sash seals. E-9.   RELAY TEST WIRE Fabricate the relay test wire according to the following steps. Refer to the following parts list for materials. Material Description National Stock Number Cut Length Wire, Electrical (MIL-W-16878) 6145-00-330-3318 6 in. (152 mm) a.  Dimensions are in inches (millimeters). b.  Cut a length of wire six inches (152 mm) long. c.  Remove approximately 3/4 in. (19 mm) of electrical insulation from each end of wire. E-10.   WHEEL BEARING SHIM TOOL REST Fabricate  the  wheel  bearing  shim  tool  rest  according  to  the  following  steps.    Refer  to  the  following  parts  list  for materials. Part Number National Stock Number Description QQ-T-570 9510-00-866-1037 Bar, Metal a.  Dimensions are in inches (millimeters). b.  Cut metal bar to 9.0 inches (228.6 mm) long. c.  De-burr and remove sharp edges from ends of metal bar. E-12 TM 9-2320-365-20-1