KNOWN INFO
CAUTION
Read CAUTION
on following page.
TEST OPTIONS
POSSIBLE PROBLEMS
Faulty start and charging cable
assembly.
Faulty dashboard cable
assembly.
19.
e2. ENGINE DOES NOT CRANK (CONT)
REASON FOR QUESTION
If continuity is not present,
wire 74 is faulty. If continuity
is present, wire 74 is faulty.
Transmission pushbutton
shift selector in neutral (N).
Batteries OK.
Service drive lights OK.
Circuit breakers OK.
Starting motor OK.
Battery to starter cable
assembly OK.
Oil pressure switch OK.
Neutral start relay OK.
WTEC II vehicle interface
module (VIM) OK.
WTEC II cab transmission
wiring harness OK.
WTEC II transmission ECU
pushbutton shift selector
(TEPSS) OK.
Relay K26 OK.
WTEC III transmission
pushbutton shift selector
(TPSS) OK.
Engine control cable assembly
OK.
Relay K24 OK.
Relay K1 OK.
Starter pushbutton switch OK.
Continuity Test or
STE/ICE-R Test #91
NO
YES
Is continuity present from
relay K1 socket 87 on PDP
to connector J43 socket 8?
Repair wire 74 from relay K1 socket 87 on
PDP to connector J43 socket 8 (para 2-40) or
replace WTEC II dashboard cable assembly
(para 7-10) or WTEC III dashboard cable
assembly (para 7-11).
Repair wire 74 from connector P43 pin 8
to terminal TL33 (para 2-40) or replace start and
charging cable assembly (para 7-82).
TM 9-2320-365-20-1
2-190 Change 1
