e2. ENGINE DOES NOT CRANK (CONT)
KNOWN INFO
CAUTION
Read CAUTION
on following page.
TEST OPTIONS
Replace WTEC II vehicle
interface module (VIM) (para 8-6).
YES
NO
Transmission pushbutton
shift selector in neutral (N).
Batteries OK.
Service drive lights OK.
Circuit breakers OK.
Starting motor OK.
Battery to starter cable
assembly OK.
Oil pressure switch OK.
WTEC II cab transmission
wiring harness OK.
WTEC II transmission ECU
pushbutton shift selector
(TEPSS) OK.
Neutral start relay OK.
POSSIBLE PROBLEMS
Faulty WTEC II vehicle
interface module (VIM).
Faulty dashboard cable
assembly.
35.
REASON FOR QUESTION
If continuity is not present,
WTEC II vehicle interface
module (VIM) is faulty. If
continuity is present, wire
1691 is faulty.
Continuity Test or
STE/ICE-R Test #91
Is continuity present from
VIM neutral start relay
socket 30 to VIM connector
pin G1?
Repair wire 1691 from connector PX33 socket
G1 to relay K1 socket 86 on PDP (para 2-40)
or replace WTEC II dashboard cable assembly
(para 7-10).
TM 9-2320-365-20-1
2-222 Change 1
