Install plastic cable ties as required.
(1) Position front grille on cab with washer and
screw.
(2) Position two washers and screws in front
grille.
(3) Tighten screw to 48-60 lb-in. (5-7 N.m).
(4) Tighten two screws to 24 lb-in. (3 N.m).
(5) Set multimeter to ohms.
(6) Connect positive (+) probe of multimeter to
terminal lug TL48.
(7) Connect negative (-) probe of multimeter to
terminal lug TL62 and note reading on
multimeter.
(8) If continuity is not present, go to step 8 of
this fault.
NOTE
CONTINUITY TEST
Change 1 2-256.3
TM 9-2320-365-20-1