CAUTION
CONTINUITY TEST
CONTINUITY TEST
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
NOTE
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
Change 1 2-367
TM 9-2320-365-20-1
(1) Remove instrument panel for access (para
7-15).
(2) Disconnect connector P31 from connector
J31.
(3) Raise cab (TM 9-2320-365-10).
(4) Disconnect connector clamp from connector
P39.
(5) Disconnect connector P39 from connector
J39.
(6) Set multimeter to ohms.
(7) Connect positive (+) probe of multimeter to
connector P39 socket 2.
(8) Connect negative (-) probe of multimeter to
connector P31 socket 17 and note reading
on multimeter.
(9) If continuity is not present, repair wire 32 in
engine control cable (para 2-40) or replace
engine control cable assembly (para 7-72).
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
connector P39 pin 1.
(3) Connect negative (-) probe of multimeter to
connector P31 socket 9 and note reading on
multimeter.
(4) If continuity is not present, repair wire 3028
in engine control cable (para 2-40) or
replace engine control cable assembly (para
7-72).
