CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
CONTINUITY TEST
Change 1 2-377
TM 9-2320-365-20-1
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
connector PX17A socket 2.
(3) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4) If continuity is not present, repair wire 3020
from connector PX17A socket 2 to
connector PX12A socket 2 (para 2-40) or
replace WTEC II dashboard cable assembly
(para 7-10) or WTEC III dashboard cable
assembly (para 7-11).
(5) If continuity is present, repair wire 1908
from connector PX17A socket 1 to
connector PX6 socket 2 (para 2-40) or
replace WTEC II dashboard cable assembly
(para 7-10) or WTEC III dashboard cable
assembly (para 7-11).
(6) Connect connector PX17A to master power
switch lamp base connector.
(7) Install instrument panel assembly (para
7-15).
