TM 9-2320-365-20-12-431CONTINUITY TEST(14) Tighten four screws to 6-10 lb-in. (1 N·m).(1) Loosen four captive screws in lamp mountingpanel.(2) Remove lamp mounting panel from lightedindicator display housing.(3) Remove left turn signal indicator lamps fromprinted circuit board.(4) Set multimeter to ohms.(5) Check continuity through each left turn signalindicator lamp and note reading onmultimeter.(6) If continuity is not present, replace lamps (para 7-16).(7) If continuity is present, replace lightedindicator display (para 7-16).(8) Install left turn signal indicator lamps inprinted circuit board.(9) Install lamp mounting panel in lightedindicator display housing.(10) Tighten four captive screws in lampmounting panel.(11) Disconnect batteries (para 7-48).(12) Connect lighted indicator display to connectorPX7.(13) Position lighted indicator display in instrumentpanel assembly with four screws.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
