TM 9-2320-365-20-1
2-437
CONTINUITY TEST
(1) Disconnect batteries (para 7-48).
(2) Remove PDP cover (para 16-2).
(3) Remove three screws and washers from PDP.
(4) Remove three screws from PDP.
(5) Lift PDP outward to gain access.
(6) Connect positive (+) probe of multimeter to
TB1 position 41.
(7) Connect negative (-) probe of multimeter to
TB1 position 42 and note reading on
multimeter.
(8) If continuity is not present, repair wire 1580
from TB1 position 41 to TB1 position 42
(para 2-40) or replace WTEC II dashboard cable
assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(9) If continuity is present, repair wire 1580 in
dashboard cable assembly (para 2-40) or
replace WTEC II dashboard cable assembly
(para 7-10) or WTEC III dashboard cable
assembly (para 7-11).
(10) Install PDP on dashboard with three screws.
(11) Install three washers and screws in PDP.
(12) Install PDP cover (para 16-2).
(13) Connect lighted indicator display to connector
PX7.
(14) Position lighted indicator display in instrument
panel assembly with four screws.
(15) Tighten four screws to 6-10 lb-in. (1 N·m).
(16) Connect batteries (para 7-48).
