TM 9-2320-365-20-1
2-489
CONTINUITY TEST
(1) Remove kick panel (para 16-3).
(2) Disconnect connector clamp from connector
P115.
(3) Disconnect connector P115 from WTEC III
transmission ECU.
(4) Set multimeter to ohms.
(5) Connect positive (+) probe of multimeter to
connector PX7-20.
(6) Connect negative (-) probe of multimeter to
connector P115-19 and note reading on
multimeter.
(7) If continuity is not present, repair wire 105
(para 2-40) or replace WTEC III dashboard
cable assembly (para 7-11).
(8) If continuity is present, replace WTEC III
transmission ECU (para 8-7).
(9) Connect connector P115 to WTEC III
transmission ECU.
(10) Connect connector clamp to connector P115.
(11) Install kick panel (para 16-3).
(12) Connect lighted indicator display to connector
PX7.
(13) Position lighted indicator display in instrument
panel assembly with four screws.
(14) Tighten four screws to 6-10 lb-in. (1 N·m).
(15) Connect batteries (para 7-48).
