TM 9-2320-365-20-12-531CONTINUITY TESTWARNINGRemove rings, bracelets, watches, necklaces,and any other jewelry before working aroundvehicle. Jewelry can catch on equipment andcause injury or short across electrical circuitand cause severe burns or electrical shock.VOLTAGE TEST(1) Set multimeter to ohms.(2) Connect positive (+) probe of multimeter toPDP, terminal 85, where relay K8 wasremoved.(3) Connect negative (-) probe of multimeter toground and note reading on multimeter.(4) If continuity is not present, repair wire 3053(para 2-40) or replace WTEC II dashboardcable assembly (para 7-10) or WTEC IIIdashboard cable assembly (para 7-11).(5) If continuity is present, replace relay K8(para 7-9).(6) Install relay K8 in PDP.(7) Install PDP cover (para 16-2).(1) Remove instrument panel assembly for access(para 7-15).(2) Disconnect connector P18 from connectorJ18.(3) Set multimeter to volts dc.(4) Connect positive (+) probe of multimeter toconnector P18-3.(5) Connect negative (-) probe of multimeter toground.(6) Position main light switch to SER DRIVE(TM 9-2320-365-10) and note reading onmultimeter.(7) If 12 vdc is not present, repair wire 16A(para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11).(8) Position main light switch to OFF(TM 9-2320-365-10).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
