CONTINUITY TEST
(5) Set multimeter to ohms.
(6) Connect positive (+) probe of multimeter
to terminal lug TL131.
(7) Connect negative (-) probe of multimeter
to terminal lug TL134 and note reading
on multimeter.
(8) If continuity is not present, repair wire
3096 from terminal lug TL134 to terminal
lug TL131 (para 2-40) or replace RH door
and cab marker lights cable assembly
(para 7-57).
(9) If continuity is present, replace RH door
marker light (para 7-31).
(10) Install gasket on RH cab marker light base.
(11) Connect marker light connector to
connector P132.
(12) Install lockwasher, terminal lug TL134,
lockwasher, and nut on back of RH cab
marker light base.
(13) Install RH cab marker light base on vehicle
with four screws.
(14) Install RH cab marker light lamp in socket.
(15) Install lens cover on base with two screws.
Change 1 2-560.5
TM 9-2320-365-20-1
(3) Extend base and disconnect connector P132
from marker light connector.
(4) Remove gasket from RH cab marker light
base. Discard gasket.
(2) Remove nut, lockwasher, terminal lug TL134,
and lockwasher from RH cab marker light
base. Discard lockwashers.
NOTE
Do not let wires slip through
hole into cab structure. If wires
slip into cab structure, vehicle
will need further disassembly
to retrieve wires.
(1) Remove four screws from RH cab marker
light base.
(16) Install gasket on RH door marker light base.
(17) Connect marker light connector to
connector P131.
(18) Install lockwasher, terminal lug TL131,
lockwasher, and nut on back of RH door
marker light base.
(19) Install RH door marker light base on vehicle
with four screws.
(20) Install RH door marker light lamp in socket.
(21) Install lens cover on base with two screws.
