Change 1 2-567
TM 9-2320-365-20-1
CONTINUITY TEST
Light
Table 2-11.2. Cab Clearance and Marker Light Terminal Lugs
Terminal Lug
Wire Segment
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter
to terminal lug (refer to Table 2-11.2. Cab
Clearance and Marker Light Terminal Lugs).
(3) Connect negative (-) probe of multimeter to
to ground and note reading on multimeter.
(4) If continuity is not present, repair wire
3097 (para 2-40) or replace cab clearance
and marker lights cable assembly (para
7-59) or M1081 cab clearance and marker
lights upper cable assembly (para 7-56).
(5) If continuity is present, replace marker light
assembly (para 7-31).
(6) Install gasket on marker light base.
(7) Connect connector (refer to Table 2-11.2.
Cab Clearance and Marker Light
Connectors) to marker light connector.
(8) Install lockwasher, terminal lug (refer to
Table 2-11.2. Cab Clearance and Marker
Light Terminal Lugs), lockwasher, and nut
on back of base.
(9) Install marker light base on vehicle with four
screws.
(10) Install marker light lamp in socket.
(11) Install lens cover on base with two screws.
RH Cab Top Marker Light
RH Cab Top ID Light
Middle Cab Top ID Light
LH Cab Top ID Light
LH Cab Top Marker Light
TL3
TL4
TL8
TL22
TL27
TL3 to splice E24
TL4 to splice E24
TL8 to splice E24
TL22 to splice E24
TL27 to splice E24
