CONTINUITY TEST
(1) Remove nut, lockwasher, terminal lug TL16
and lockwasher from LH rear marker light
screw. Discard lockwashers.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter to
terminal lug TL16.
(4) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5) If continuity is not present, repair wire 3094
from terminal lug TL16 to ground (para 2-40)
and go to step 5 of this fault if required or
replace rear lights cable assembly
(para 7-75) and go to step 1 of this fault.
(6) If continuity is present, repair wire 489 from
splice E15 to splice E16 (para 2-40) and
go to step 5 of this fault if required or
replace rear lights cable assembly
(para 7-75) and go to step 1 of this fault.
(7) Install lockwasher, terminal lug TL16,
lockwasher, and nut on LH rear marker
light screw.
Change 1 2-584.25
TM 9-2320-365-20-1
