CONTINUITY TEST
(1) Remove two screws, lockwashers, RH
composite taillight assembly, and
terminal lug TL21 from right taillight
carrier. Discard lockwashers.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter to
terminal lug TL21.
(4) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5) If continuity is not present, repair wire 3095
from terminal lug TL21 to terminal lug TL92
(para 2-40) or replace rear lights cable
assembly (para 7-75).
(6) If continuity is present, replace RH
composite taillight assembly (para 7-32).
(7) Install terminal lug TL21, and RH composite
taillight assembly on right taillight carrier with
two lockwashers and screws.
Change 1 2-593
TM 9-2320-365-20-1
(8) Connect connector P64 to RH composite
taillight assembly.
(9) Install RH composite taillight lamp in socket.
(10) Install preformed packing and cover on RH
composite taillight assembly with six screws.
