TM 9-2320-365-20-12-613WARNINGRemove rings, bracelets, watches, necklaces,and any other jewelry before working aroundvehicle. Jewelry can catch on equipment andcause injury or short across electrical circuitand cause severe burns or electrical shock.VOLTAGE TEST(1) Remove PDP cover (para 16-2).(2) Remove three screws and washers from PDP.(3) Remove three screws from PDP.(4) Lift PDP outward to gain access.(5) Disconnect connector J27 from connectorP27.(6) Set multimeter to volts dc.(7) Connect positive (+) probe of multimeter toJ27-7.(8) Connect negative (-) probe of multimeter toground.(9) Position main light switch to BO DRIVE(TM 9-2320-365-10) and note reading onmultimeter.(10) If 12 vdc is not present, repair wire 19(para 2-40) or replace WTEC II dashboard cableassembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11).(11) Position main light switch to OFF(TM 9-2320-365-10).(12) Connect connector J27 to connector P27.(13) Install PDP on dashboard with three screws.(14) Install three washers and screws in PDP.(15) Install PDP cover (para 16-2).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
