TM 9-2320-365-20-2
2-1229
VOLTAGE TEST
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
WARNING
(1) Push in circuit breaker CB11
(TM 9-2320-365-10).
(2) Push in circuit breaker CB10
(TM 9-2320-365-10).
(3) Position INTERIOR LIGHTS switch S32 to ON
(TM 9-2320-365-10).
(4) Set multimeter to volts dc.
(5) Connect positive (+) probe of multimeter to
pin 1 of P connector. Refer to Table 2-14.
M1079 Blackout Light Locations and
Connector Numbers.
(6) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(7) If 24 vdc is not present, repair or replace
wire 1505(B) (para 2-40).
(8) If 24 vdc is present, repair or replace wire
3086 (para 2-40).
(9) Position INTERIOR LIGHTS switch S32 to
OFF (TM 9-2320-365-10).
(10) Pull out circuit breaker CB10
(TM 9-2320-365-10).
(11) Pull out circuit breaker CB11
(TM 9-2320-365-10).
(12) Install blackout light (para 16-58).
