TM 9-2320-365-20-2
2-1103
CONTINUITY TEST
CONTINUITY TEST
(1) Remove kick panel (para 16-3).
(2) Disconnect connector P108 from connector
J108.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter to
connector P173C.
(5) Connect negative (-) probe of multimeter to
connector P108-4 and note reading on
multimeter.
(6) If continuity is not present, repair wire 2040
(para 2-40) or replace M1079 12/24 vdc
power cable (para 7-51).
(7) Connect connector P173 to connector J173.
(1) Remove personnel heater (para 18-9).
(2) Disconnect connector J912 from connector
P912.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter to
connector J108-4.
(5) Connect negative (-) probe of multimeter to
connector J912-10 and note reading on
multimeter.
(6) If continuity is not present, repair wire 2040
(para 2-40) or replace auxilliary panel cable
assembly (all models except M1079 w/o
winch) (para 7-49) or M1079 w/o winch
auxiliary panel cable assembly (para 7-50).
(7) If continuity is present, repair wire 2040
(para 2-40) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(8) Connect connector J912 to connector P912.
(9) Connect connector P108 to connector J108.
(10) Install personnel heater (para 18-9).
