CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
CONTINUITY TEST
Change 1 2-1483
TM 9-2320-365-20-2
(1) Connect connector P116 to WTEC II VIM.
(2) Tighten screw in connector P116.
(3) Remove instrument panel assembly for
access (para 7-15).
(4) Disconnect connector J115 from WTEC II
TEPSS.
(5) Set multimeter ohms.
(6) Connect positive (+) probe of multimeter to
connector P115 socket 2.
(7) Connect negative (-) probe of multimeter to
connector J115 socket 11 and note reading
on multimeter.
(8) If continuity is not present, replace WTEC II
cab transmission harness (para 7-86).
(9) If continuity is present, replace WTEC II
TEPSS (para 8-2).
(10) Install kick panel (para 16-3).
(11) Connect batteries (para 7-48).
