CONTINUITY TEST CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes.  Failure to comply may result in damage to equipment. NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability.  Check that connector pins are not pushed back and are capable of making good contact. CONTINUITY TEST (CONT) Change 1         2-1495 TM 9-2320-365-20-2 Loose or dirty connectors may cause intermittent loss of power to transmission ECU and diagnostic codes to be logged. Ensure that all connectors are clean and tight before performing troubleshooting.  Failure to comply may result in incorrect test results.   (1)  Remove two screws and washers from         front grille.   (2)  Remove screw and washer from front         grille.   (3)  Remove front grille from cab.   (4)  Disconnect connector P119 from connector         J119.   (5)  Remove kick panel (para 16-3).   (6)  Disconnect connector clamp from         connector P114.   (7)  Disconnect connector P114 from WTEC III         transmission ECU.   (8)  Install jumper wire from connector J119p         to J119r.   (9)  Set multimeter to ohms. (10)  Connect positive (+) probe of multimeter to         connector P114-15. (11)  Connect negative (-) probe of multimeter to         connector P114-31 and note reading on         multimeter. (12)  Connect negative (-) probe of multimeter to         all other sockets in connector P114, one at a         time, and note reading on multimeter. (13)  Connect negative (-) probe of multimeter to         ground and note reading on multimeter. (14)  Remove jumper wire from connector J119r         and J119p. (15)  Connect positive (+) probe of multimeter to         connector P114-31. (16)  Connect negative (-) probe of multimeter to         all sockets in connector P114 (except         P114-15), one at a time, and note reading on         multimeter. (17)  Connect negative (-) probe of multimeter to         ground and note reading on multimeter. (18) If continuity is not present in step 11, or        continuity is present in step 12, 13, 16, or        17, replace WTEC III cab transmission        harness (para 7-138). (19) Connect connector P114 to WTEC III        transmission ECU. (20) Connect connector clamp to connector        P114. (21) Install kick panel (para 16-3).