Change 1 2-1501
TM 9-2320-365-20-2
RESISTANCE TEST
(1) Remove two screws and washers from
front grille.
(2) Remove screw and washer from front
grille.
(3) Remove front grille from cab.
(4) Disconnect connector P119 from
connector J119.
(5) Set multimeter to ohms.
(6) Connect positive (+) probe of multimeter
to connector P119n.
(7) Connect negative (-) probe of multimeter
on connector P119g and note reading on
multimeter.
(8) Connect negative (-) probe of multimeter
to all other pins in connector P119, one
at a time, and note reading on
multimeter.
(9) Connect negative (-) probe of multimeter
to ground and note reading on
multimeter.
(10) Connect positive (+) probe of multimeter
to connector P119g.
(11) Connect negative (-) probe of multimeter
to all other pins in connector P119
(except P119n), one at a time, and note
reading on multimeter.
(12) Connect negative (-) probe of multimeter
to ground and note reading on multimeter.
(13) If 200-400 ohms resistance is not present
in step 7, or continuity is present in step
8, 9, 11, or 12, notify DS Maintenance.
