TM 9-2320-365-20-2 WINCH CONTROL VALVE PRESSURE TEST (12)  Disconnect STE/ICE-R and tee. (13)  Connect hose fitting to port V1. (14)  Disconnect hose (below elbow) from         port V2. (15)  Connect STE/ICE-R with tee between         hose and port V2. (16)  Start engine (TM 9-2320-365-10). (17)  Position PTO and WINCH POWER         switches to on (TM 9-2320-365-10). (18)  Perform STE/ICE-R test #51 and         toggle WINCH IN/OUT switch to OUT         (TM 9-4910-571-12&P). (19)  Check if pressure reading is between         2000-2100 psi (13790-14480 kPa). (20)  If pressure is lower than 2000 psi, notify         DS Maintenance. (21)  Release load and retrieve cable         (TM 9-2320-365-10). (22)  Position WINCH POWER and PTO         switches to off (TM 9-2320-365-10). (23)  Disengage winch clutch (TM         9-2320-365-10). (24)  Shut down engine (TM 9-2320-365-10). (25)  Disconnect STE/ICE-R and tee. (26)  Connect hose fitting to port V2.   (1)  Disconnect hose from fitting below         elbow at port V1 (on side of         11K self-recovery winch toward front of         vehicle).   (2)  Connect STE/ICE-R with tee between         port V1 and hose.   (3)  Start engine (TM 9-2320-365-10).   (4)  Attach stall load to winch cable         (TM 9-2320-365-10).   (5)  Position PTO switch and WINCH         POWER switch to ON (TM         9-2320-365-10).   (6)  Engage winch clutch (TM         9-2320-365-10).   (7)  Perform STE/ICE-R test #51 and toggle         WINCH IN/OUT switch to IN position         and hold (TM 9-4910-571-12&P).   (8)  Check if pressure reading is between         2000-2100 psi (13790-14480 kPa) on         STE/ICE-R.   (9)  If pressure is less than 2000 psi         (13790 kPa), notify DS Maintenance. (10)  Position WINCH POWER and PTO         switches to off (TM 9-2320-365-10). (11)  Shut down engine (TM 9-2320-365-10). 2-1949