TM 9-2320-365-20-3
6-13. DRIVE BELT AND TENSION PULLEY REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Top radiator fan shroud removed (para 6-4).
Tools and Special Tools
Tool Kit, Genl Mech (Item 44, Appendix C)
Gage, Belt Tension (Item 15, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 57, Appendix C)
Materials/Parts
Antiseize Compound (Item 63, Appendix D)
Lockwasher (6) (Item 91, Appendix G)
Screw, Self-Locking (6) (Item 242, Appendix G)
Grommet, Nonmetallic (Item 49, Appendix G)
a. Removal.
CAUTION
Mark front of engine fan before removing.
Failure to comply may result in damage to
equipment.
(1) Remove air hose (1) from
fitting (2) on fan clutch
assembly (3).
(2) Remove fitting (2) from fan clutch assembly (3).
NOTE
Perform steps (3) through (6) on vehicles
serial number 8426 and lower that have not
had the fan clutch replaced.
(3) Remove six screws (4), lockwashers (5), and washers
(6) from engine fan (7).
Discard lockwashers and
screws.
(4) Remove engine fan (7) from fan clutch assembly (3).
(5) Remove fan support plate (8) from engine fan (7).
(6) Remove grommet (9) from engine fan (7). Discard
grommet.
6-70
Change 1
