TM 9-2320-365-20-4
(60) Install three louvers (73) on cover (74).
(61) Install cover (74) on personnel heater (2) with seven
screws (75).
(62) Position personnel heater control guard (76) on cover
(74) with four washers (77) and screws (78).
(63) Tighten four screws (78) to 39-59 lb-in. (4-7 N·m).
(64) Install control panel (79) on personnel heater (2) with six
screws (80).
NOTE
Perform steps (65) and (67) on vehicle serial
numbers 0001 through 3696 equipped with
original personnel heaters.
(65) Position three self-locking nuts (81) on DEFR control
cable (19), VENT control cable (25), and HEAT control
cable (57).
(66) Install knobs (82, 83, and 84) on DEFR control cable
(19), VENT control cable (25), and HEAT control cable
(57).
(67) Tighten three self-locking nuts (81) on knobs (82, 83,
and 84).
18-53