TM 9-2320-365-20-4
NOTE
Step (3) requires the aid of an assistant.
(3) Position door (7) on cab with hinge (1) in slot in forward
edge of door and bolt holes aligned with openings in
door.
(4) Position door (7) on hinge (1) with three washers (8)
and screws (9).
(5) Position door (7) on hinge (4) with three washers (10)
and screws (11).
(6) Adjust door (7) so that gap between door and cab is
approximately equal all around.
(7) Tighten three screws (9 and 11) one-half turn.
(8) Open, close, and open door (7) to ensure correct
operation.
(9) Tighten three screws (9 and 11) to 22-26 lb-ft (30-35
N·m).
(10) Apply grease to hinges (1 and 4).
(11) Install four clip nuts (12) on door (7).
(12) Install wiring harness (13) through access hole in forward
edge of door (7).
(13) Install door arrestor assembly (14) on cab with washer
(15), two spring washers (16), and screw (17).
(14) Install door arrestor assembly (14) on bottom of door (7)
with two screws (18).
16-35