TM 9-2320-365-20-5
13. TIE ROD ENDS.
Lubricate tie rod ends with GAA every 6,000 miles (9,654 km) or once every six months,
whichever occurs first, using a low pressure lubrication gun, until new grease is seen purging from the boot area. If
operating conditions are severe or abnormal, service at 1,000 miles (1,609 km) or once every month, whichever occurs
first.
14. 11K SELF-RECOVERY WINCH (SRW) CABLE:
CAUTION
Do not use dry cleaning solvent to clean 11K Self-Recovery Winch (SRW) cables. Use of dry cleaning
solvent will remove lubricant from inner strands of 11K SRW cables. Failure to comply may result in
damage to equipment.
a. After winch operation:
Refer to FM 5-125.
b. Care of wire rope:
Refer to FM 5-125.
c. Inspection of wire rope:
Refer to FM 5-125.
d. Every six months:
(1) Unwind entire length of 11K SRW cable (TM 9-2320-365-10).
(2) Soak and clean 11K SRW cable with new OE/HDO 30.
(3) Wipe off excess OE/HDO 30.
(4) Coat 11K SRW cable with GW.
(5) Rewind 11K SRW cable (TM 9-2320-365-10).
15. 11K SRW. Check 11K SRW gear oil level every 6,000 miles (9,654 km) or once every six months, whichever
occurs first. Refill 11K SRW with GO specified for ambient temperature. Change oil every 12,000 miles (19,308 km)
or once every year, whichever occurs first. Use procedure (a) to check and fill oil level; use procedure (b) to change
oil.
a. Check and fill oil level as follows:
(1) Shift the freespool mechanism to the disengage position so the drum can be freely rotated.
(2) Rotate the drum to where either plug is near the top of the 11K SRW. Remove the plug.
(3) Rotate the drum 90 degrees in the direction that allows the other plug to be near the top of the 11K SRW.
Remove the plug.
NOTE
Oil level is full if a small amount of oil runs out of lower plug.
(4) Add oil until a small amount of oil runs out of lower plug hole.
(5) Apply adhesive (Item 2, Appendix D) to plug and position plug in top hole.
(6) Rotate drum until open hole is at top.
(7) Apply adhesive (Item 2, Appendix D) to plug and position plug in top hole.
(8) Tighten plugs to 13-15 lb-ft (18-20 N·m).
Change 1
H-19
