TM 9-2320-365-20-5
(82) Route heater fuel pump power cable (143) through hole
in pod panel (134).
(83) Remove screw (144), lockwasher (145), washer (146),
and terminal lug TL191 (147) from bracket (148).
(84) Disconnect connector J314 (149) from heater fuel pump
power cable connector (150).
(85) Install dust cap (151) on heater fuel pump power cable
connector (150).
(86) Install dust cap (152) on fuel inlet port (138).
(87) Install dust cap (153) on fuel overflow port (142).
(88) Install dust cap (154) on heater power cable connector
(38).
(89) Remove four screws (155), lockwashers (156), and
washers (157) from heater duct (158).
Discard
lockwashers.
20-219
