CONTINUITY TEST
(1) Remove nut, lockwasher, terminal lug TL20,
and lockwasher from RH marker light screw.
Discard lockwashers.
(2) Connect positive (+) probe of multimeter to
terminal lug TL20.
(3) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4) If continuity is not present, repair wire 3095
from terminal lug TL20 to terminal lug TL21
(para 2-40) and go to step 6 of this fault if
required or replace rear lights cable assembly
(para 7-75) and go to step 1 of this fault.
(5) If continuity is present, replace RH marker
light and go to step 6 of this fault if required.
(6) Install lockwasher, terminal lug TL20,
lockwasher, and nut on RH marker light
screw.
(7) Connect RH marker light connector to
connector P89.
Change 1 2-584.47
TM 9-2320-365-20-1