23-6. AIR DRYER REPLACEMENT/REPAIR (CONT)
(2) Install 90-degree fitting (4) in lower cover (5).
When installing a new air dryer, it is
necessary to change the orientation of the
retaining bands. Failure to comply may result
in damage to equipment.
Perform steps (3) through (5) if installing a
new air dryer.
(3) Loosen two nuts (6) on retaining bands (7).
Position retaining bands on air dryer as noted
(4) Rotate two retaining bands (7) 90-degrees clockwise as
viewed from top of air dryer (8).
(5) Tighten two nuts (6) on retaining bands (7).