TM 9-2320-365-20-1VOLTAGE TEST(1) Remove circuit breaker CB76 from PDP.(2) Set multimeter to volts dc.(3) Connect positive (+) probe of multimeterto PDP, terminal 3, where circuit breaker CB76 was removed.(4) Connect negative (-) probe of multimeter toground.(5) Position master power switch to on(TM 9-2320-365-10) and note reading onmultimeter.(6) If 12 vdc is not present, repair wire 1548(para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11).(7) If 12 vdc is present, repair wire 1641(para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC IIIdashboard cable assembly (para 7-11).(8) Position master power switch to off(TM 9-2320-365-10).(9) Install circuit breaker CB76 in PDP.(10) Install relay K6 in PDP.(11) Install PDP cover (para 16-2).Remove rings, bracelets, watches, necklaces,and any other jewelry before working aroundvehicle. Jewelry can catch on equipment andcause injury or short across electrical circuitsand cause severe burns or electrical shock.WARNING2-749
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
